The intercom system incorporates pilot isolate and crew modes, two stereo (or mono de- pending on unit) music inputs with "Soft Mute and LED indicators for swap and trans- mit.
3 amp b) Speaker, 4 c) Headphone Jacks (Stereo, as Required) d) Microphone Jacks (as Required) e) Headphones, 150 (Stereo up to 6 as required f) Microphones, up to 6 as required g) Marker Antenna (75 MHz, vswr 1:1.5, 50 ohm, and cable (RG400 R/U).Because the rotary microphone selector switch controls what transceiver is being heard, the Com l and Com 2 push-buttons are of the momentary type and do not remain in when selected.Before installing and/or using mitsubishi lancer 1999 service manual.pdf generation dead daniel waters.pdf this product, please read this manual completely.By Federal Communications Com- mission (FCC) regu.Bendix/King KMA28 Audio Amplifier/Intercom/Marker Beacon Receiver Section I general manual for 1998 gmc z71 4x4 value information.1 introduction The KMA 28 represents the next step in cockpit audio control and intercommunications.Failure to do so will cause serious inter- nal damage and void the warranty.Please read this manual carefully before beginning any installation to prevent damage and post-installation problems.Response, 3 dB: 100 Hz - 18kHz marker beacon receiver Frequency: 75 MHz Crystal Controlled Capable of: Sensitivity: 1000 Volts (Hard.Install the tray using six FHP 6-32 x " screws.
Connect a ramp generator at the antenna end of the marker coax.
Audio Amplifier /Intercom marker Beacon Receiver, document P/N.The audio signal at the entertainment input must be a minimum of 500 mV P-P per channel for optimum music performance.Reproduction of this publication, or any portion thereof, by any means without the express written.Press enter to search.KMA28 Audio Selector Panel/Intercom System with internal Marker Beacon.Installation of this equipment requires special tools and knowledge.This system has the advanced IntelliVox circuitry that eliminates manual adjustments.The connectors are a Molex crimp-type, and require the use of a Molex hand crimp tool, EDP P/N, CR6115B (o.2.11 Unit Installation To install the KMA 28, gently slide the unit into the mounting rack until the hold-down screw is engaged.The unit is designed for outstanding ergonomics and visually de- fined mode annunciation and selection.This is also part of the "au).Marker Gain CW- Reduce MKR Low Sense CW Decrease Sens.Use a 2-conductor with shield cable, and connect the shield to Pin M of the.
Revision 0, september 2000, warning, prior to export of this document, review for export license requirement is needed.
KMA 28, fAA-Approved TSO C50c, C35d, jAA-Approved jtso-2C35d, C50c.